No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
security-profile (Mesh profile view)

security-profile (Mesh profile view)


The security-profile command binds a security profile to a Mesh profile.

The undo security-profile command restores the default security profile bound to a Mesh profile.

By default, the security profile default-mesh is bound to a Mesh profile.


security-profile profile-name

undo security-profile






Specifies the name of the security profile bound to a Mesh profile.

The security profile must exist.


Mesh profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Before a Mesh profile is applied to an AP radio to establish Mesh links, the Mesh profile must have a security profile bound to ensure Mesh link security.


After a security profile is bound to a Mesh profile, the authentication policy and encryption mode in the security profile cannot be changed, but the authentication key can be changed.

A Mesh profile can only have one security profile bound. If you run the command multiple times in the same Mesh profile view, the latest configuration overwrites the old one.


# Create the security profile sec and set the security policy to WPA2+PSK+AES. Create the Mesh profile test and bind the security profile to the Mesh profile.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] security-profile name sec
[HUAWEI-wlan-sec-prof-sec] security wpa2 psk pass-phrase huawei@123 aes
[HUAWEI-wlan-sec-prof-sec] quit
[HUAWEI-wlan-view] mesh-profile name test
[HUAWEI-wlan-mesh-prof-test] security-profile sec
Warning: This action may cause service interruption. Continue?[Y/N]y
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127105

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next