No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
flood-detect interval

flood-detect interval


The flood-detect interval command sets the flood attack detection interval.

The undo flood-detect interval command restores the default flood attack detection interval.

By default, the flood attack detection interval is 10 seconds.


flood-detect interval interval

undo flood-detect interval





interval interval

Specifies the interval for flood attack detection.

The value is an integer that ranges from 10 to 120, in seconds.


WIDS profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

A flood attack occurs when an AP receives a large number of packets of the same type within a short period. As a result, the AP is flooded by too many attack packets to process service packets from authorized wireless terminals.

After the flood attack detection function is enabled, an AP counts the number of packets of the same type that it receives from a user at regular intervals. When the number exceeds a specified threshold, the AP considers that the user launches a flood attack. If the dynamic blacklist function is enabled, the user will be added to a dynamic blacklist.

Follow-up Procedure

Run the dynamic-blacklist enable command to enable the dynamic blacklist function.


# Set the flood attack detection interval to 120s.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-group name office
[HUAWEI-wlan-ap-group-office] radio 0
[HUAWEI-wlan-group-radio-office/0] wids attack detect enable flood
[HUAWEI-wlan-group-radio-office/0] quit
[HUAWEI-wlan-ap-group-office] quit
[HUAWEI-wlan-view] wids-profile name huawei
[HUAWEI-wlan-wids-prof-huawei] flood-detect interval 120
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127037

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next