No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
sta-load-balance dynamic deny-threshold

sta-load-balance dynamic deny-threshold


The sta-load-balance dynamic deny-threshold command sets the maximum number of times an AP rejects association requests of a STA for dynamic load balancing.

The undo sta-load-balance dynamic deny-threshold command restores the default maximum number of times an AP rejects association requests of a STA for dynamic load balancing.

By default, the maximum number of rejections is 3.


sta-load-balance dynamic deny-threshold deny-threshold

undo sta-load-balance dynamic deny-threshold






Specifies the maximum number of times an AP rejects association requests of a STA.

The value is an integer that ranges from 1 to 10.


RRM profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

If a STA requests to associate with an AP enabled with load balancing but the AP forbids the association according to the dynamic load balancing algorithm, the AP will reject the STA's request. However, after the number of rejections exceeds the maximum value specified by sta-load-balance dynamic deny-threshold command, the AP allows the STA to associate.


This command takes effect only in channel-utilization mode.


# Set the maximum number of rejections to 8 for the terminal.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] rrm-profile name default
[HUAWEI-wlan-rrm-prof-default] sta-load-balance dynamic deny-threshold 8
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 124410

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next