No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
beacon-interval

beacon-interval

Function

The beacon-interval command sets the interval for sending Beacon frames.

The undo beacon-interval restores the default interval for sending Beacon frames.

By default, the interval for sending Beacon frames is 100 TUs.

Format

beacon-interval beacon-interval

undo beacon-interval

Parameters

Parameter

Description

Value

beacon-interval

Specifies the interval for sending Beacon frames.

The value is an integer that ranges from 60 TUs to 1000 TUs.TU is a time unit equal to 1024 microseconds.

Views

2G radio profile view, 5G radio profile view

Default Level

2: Configuration level

Usage Guidelines

An AP broadcasts Beacon frames at intervals to notify STAs of an existing 802.11 network. After receiving a Beacon frame, a STA can modify parameters used to connect to the 802.11 network.

A long interval for sending Beacon frames lengthens the dormancy time of STAs, while a short interval for sending Beacon frames increases air interface costs. Therefore, you are advised to set the interval for sending Beacon frames for an AP based on the VAP quantity. The following intervals for sending Beacon frames are recommended for APs with different VAP quantities on a single radio:
  • No more than 4 VAPs: about 100 TUs
  • 5 to 8 VAPs: about 200 TUs
  • 9 to 12 VAPs: about 300 TUs
  • 13 to 16 VAPs: about 400 TUs

Ensure that the air scan interval meets the following condition: scan-interval ≥ beacon-interval + 100 ms

Example

# Set the interval for sending Beacon frames to 200 TUs in the 2G radio profile default.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] radio-2g-profile name default
[HUAWEI-wlan-radio-2g-prof-default] beacon-interval 200 
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 115468

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next