No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
channel-switch announcement disable

channel-switch announcement disable


The channel-switch announcement disable command disables an AP from sending an announcement when the channel is switched.

The undo channel-switch announcement disable command enables an AP to send an announcement when the channel is switched.

By default, an AP sends an announcement when the channel is switched.


channel-switch announcement disable

undo channel-switch announcement disable




2G radio profile view, 5G radio profile view

Default Level

2: Configuration level

Usage Guidelines

When the AP works on a Depth First Select (DFS) channel, a radar detection is performed. The AP automatically switches to another channel because the DFS channel frequency may interfere with the radar frequency.

After the undo channel-switch announcement disable command is run, if the AP channel switches, the AP sends an Action frame to instruct STAs to switch channels after multiple Beacon intervals. The AP also switches the channel after the same intervals. The AP and STAs switch channels at the same time to prevent STA reassociations and ensure rapid service recovery.


The channel switching announcement function must be supported by both the AP and STA.


# Disable the AP from sending an announcement after the channel is switched.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] radio-2g-profile name default
[HUAWEI-wlan-radio-2g-prof-default] channel-switch announcement disable
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 123653

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next