No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
card connect-type

card connect-type

Function

The card connect-type command configures the connection type between IoT cards and APs.

The undo card connect-type command restores the default connection type between IoT cards and APs.

By default, IoT cards communicate with APs through serial interfaces.

Format

card connect-type { ethernet | serial }

undo card connect-type

Parameters

Parameter

Description

Value

ethernet

Configures IoT cards to communicate with APs through Ethernet interfaces.

-

serial

Configures IoT cards to communicate with APs through serial interfaces.

-

Views

AP system profile view, IoT card interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

When an IoT card communicates with an AP through the serial interface, the communication rate between the IoT card and AP does not exceed the maximum baud rate of the serial interface, that is, 115200 bit/s. This connection type is applicable to scenarios without high traffic volume. When an IoT card communicates with an AP through an Ethernet interface, the communication rate of 10 Mbit/s is supported. This connection mode is applicable to electronic shelf label (ESL) scenarios.

Ensure that the connection type between IoT cards and APs is supported by the IoT cards. For the connection types supported by different IoT cards, see Table 11-264.

Table 11-264  Card information

Usage Scenario

Vendor

Model

Connection Type

Part Number

ESL

Century

APSCIOT00

Ethernet

06030401

Asset management

Sense

APXSIOT00

Serial

06030403

Asset management

Sense

APXSIOT01

Serial

06030404

Smart healthcare

Enjoyor

APYJIOT00

Serial

06030402

Before using IoT cards of other vendors, contact the vendors to confirm the connection types supported by the cards.

Precautions

  • The configuration has the highest priority in the IoT card interface view of an AP, a lower priority in the IoT card interface view of an AP group, and the lowest priority in the AP system profile view.

  • Cards connected through USB ports do not support this command.

  • The modified connection type takes effect only after the AP is restarted.
  • Currently, only the AP4050DN-E supports this command.

Example

# Configure IoT cards to communicate with APs through Ethernet interfaces.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name ab
[HUAWEI-wlan-ap-system-prof-ab] card connect-type ethernet
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 128098

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next