No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
untagged vlan (soft GRE profile view)

untagged vlan (soft GRE profile view)


The untagged vlan command configures an AP to send packets through the soft GRE tunnel without carrying the VLAN tag.

The undo untagged vlan command restores the VLAN tag carried in packets sent by an AP through the soft GRE tunnel.

By default, packets sent by an AP through the soft GRE tunnel carry the VLAN tag.


untagged vlan vlan-id

undo untagged vlan


Parameter Description Value

Specifies the ID of a VLAN whose tag is to be removed.

The value is an integer that ranges from 1 to 4094.


Soft GRE profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After receiving service data packets from STAs, an AP adds the service VLAN tag to the packets and then encapsulates them over a soft GRE tunnel. In some scenarios, however, the peer device of the soft GRE tunnel cannot process VLAN-tagged packets. In this case, run the untagged vlan command to add the soft GRE interface to the specified VLAN in untagged mode. Additionally, configure the PVID of the soft GRE interface to the same as the specified VLAN. If the VLAN specified in this command is the service VLAN, the VLAN tag of packets passing through the soft GRE tunnel will be removed. The AP then sends the packets in untagged mode.


A soft GRE profile supports only one untagged VLAN.


# Configure an AP to remove VLAN tag 101 from packets and send them through a soft GRE tunnel in untagged mode.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] softgre-profile name soft1
[HUAWEI-wlan-softgre-prof-soft1] untagged vlan 101
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 123279

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next