No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
dot11bg basic-rate

dot11bg basic-rate


The dot11bg basic-rate command configures a basic rate set of the 802.11bg protocol in a 2G radio profile.

The undo dot11bg basic-rate command restores the default basic rate set of the 802.11bg protocol in a 2G radio profile.

By default, the basic rate set of the 802.11bg protocol includes rates 1 Mbps and 2 Mbps in a 2G radio profile.


dot11bg basic-rate { dot11bg-rate-value &<1-12> | all }

undo dot11bg basic-rate






Specifies an 802.11bg basic rate set.

Enumerated type:
  • 1: 1 Mbps
  • 2: 2 Mbps
  • 5: 5.5 Mbps
  • 6: 6 Mbps
  • 9: 9 Mbps
  • 11: 11 Mbps
  • 12: 12 Mbps
  • 18: 18 Mbps
  • 24: 24 Mbps
  • 36: 36 Mbps
  • 48: 48 Mbps
  • 54: 54 Mbps


Supports all basic rates.



2G radio profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The rates specified in the basic rate set must be supported by both the AP and STA; otherwise, the STA cannot associate with the AP. For example, if you configure the basic rate set to contain rates 6 Mbps and 9 Mbps and deliver the configuration to an AP, only STAs supporting the two rates can associate with the AP. The AP and STA select a rate from the basic rate set or the supported rate set to transmit packets.

After you run this command to configure a basic rate set in a radio profile, bind the radio profile to an AP or AP group. If a STA associates with the AP in 802.11bg mode, the STA must support all rates specified by the basic rate set; otherwise, the STA cannot associate with the AP.


This configuration applies only to STAs associated with an AP in 802.11bg mode but does not take effect on STAs associated with the AP in other modes.

The basic rate set and supported rate set cannot be empty simultaneously.


# Configure the 802.11bg basic rate set to contain rates 6 Mbps and 9 Mbps in the 2G radio profile default.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] radio-2g-profile name default
[HUAWEI-wlan-radio-2g-prof-default] dot11bg basic-rate 6 9
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126217

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next