No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
reset mac-address

reset mac-address

Function

The reset mac-address command deletes all dynamic, dynamic secure, and sticky MAC address entries from an AP's wired interface.

Format

reset mac-address { ap-id ap-id | ap-name ap-name } interface-type interface-number

Parameters

Parameter

Description

Value

ap-id ap-id

Deletes all dynamic, dynamic secure, and sticky MAC address entries from the wired interface of the AP with a specified ID.

The AP ID must exist.

ap-name ap-name

Deletes all dynamic, dynamic secure, and sticky MAC address entries from the wired interface of the AP with a specified name.

The AP name must exist.

interface-type interface-number
Deletes all dynamic, dynamic secure, and sticky MAC address entries from a specified interface.
  • interface-type specifies the interface type.
  • interface-number specifies the number of the outbound interface.
The following types of outbound interfaces are supported:
  • Eth-Trunk
  • Ethernet
  • Gigabitethernet
  • MultiGE

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

You can run the reset mac-address command to delete all dynamic MAC address entries from an AP's wired interface. If the port security and sticky MAC functions are enabled, dynamic secure MAC address and sticky MAC address entries are also deleted.

Example

# Delete all dynamic, dynamic secure, and sticky MAC address entries from the wired interface of the AP with ID 1.

<HUAWEI> reset mac-address ap-id 1 ethernet 0
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 116882

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next