No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
calibrate error-rate-check

calibrate error-rate-check

Function

The calibrate error-rate-check command configures the interval and traffic threshold for checking the bit error rate (BER).

The undo calibrate error-rate-check command configures the interval and traffic threshold for checking the BER.

The default interval and traffic threshold for checking the BER are 1 minute and 1250 kbit/s, respectively.

Format

calibrate error-rate-check interval interval load-threshold load-threshold

undo calibrate error-rate-check

Parameters

Parameter

Description

Value

interval interval

Specifies the interval for checking the BER.

The value is an integer that ranges from 1 to 10, in minutes.

load-threshold load-threshold

Specifies the traffic threshold for checking the BER.

The value is an integer that ranges from 1 to 20000, in kbit/s.

Views

RRM profile view

Default Level

2: Configuration level

Usage Guidelines

You can run the calibrate error-rate-check command to lower the sensitivity for collecting radio BER statistics. When the rate of network traffic reaches the threshold, BER check is performed at the specified interval.

Example

# Set the interval and traffic threshold for checking the BER in the RRM profile 80211b to 2 minutes and 1000 kbit/s, respectively.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] rrm-profile name 80211b
[HUAWEI-wlan-rrm-prof-80211b] calibrate error-rate-check interval 2 load-threshold 1000
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126435

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next