No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
priority

priority

Function

The priority command sets the AC priority in the AP system profile view.

The undo priority command restores the AC priority to the default setting in the AP system profile view.

By default, no AC priority is configured in the AP system profile view.

Format

priority priority-level

undo priority

Parameters

Parameter

Description

Value

priority-level

Specifies the AC priority.

The value is an integer that ranges from 0 to 7. A smaller value indicates a higher priority.

Views

AP system profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

When an AP goes online, ACs deliver their priorities to the AP. The AP selects the AC with the highest priority as the active AC and establishes a CAPWAP tunnel with the active AC.

Precautions

If the AC priority is configured in the WLAN view and AP system profile view before an AP goes online, the AC priority configured in the AP system profile view is delivered to the AP. If no AC priority is configured in the AP system profile view, the AC priority configured in the WLAN view is delivered to the AP.

If ACs deliver the same priorities to the AP, the AP selects the AC with the lowest AP load as the active AC. If both AC priorities and AP load are the same, the AP selects the AC with the lowest STA load as the active AC. If AC priorities, AP load, and STA load are the same, the AP selects the AC with the smallest IP address as the active AC to establish a CAPWAP tunnel. The AP or STA load equals the number of allowed APs or STAs minus the number of existing APs or STAs.

Example

# Set the AC priority to 3 in the AP system profile view.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name ap-system1
[HUAWEI-wlan-ap-system-prof-ap-system1] priority 3
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 124325

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next