No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
radio-type (2G radio profile view)

radio-type (2G radio profile view)

Function

The radio-type command sets the radio type in a 2G radio profile.

The undo radio-type command restores the default radio type in a 2G radio profile.

By default, the radio type in a 2G radio profile is dot11ax.

Format

radio-type { dot11b | dot11g | dot11n | dot11ax }

undo radio-type

Parameters

Parameter

Description

Value

dot11b

Specifies the 802.11b radio type.

-

dot11g

Specifies the 802.11b/g radio type.

-

dot11n

Specifies the 802.11b/g/n radio type.

-

dot11ax

Specifies the 802.11b/g/n/ax radio type.

-

Views

2G radio profile

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Usually, the default radio type is used and does not need to be modified. If the default radio mode cannot meet requirements or a fault needs to be located, configure the radio type as required.

Precautions

If a rate in the basic rate set or supported rate set, or the multicast rate is not supported by the 802.11b protocol, the radio type cannot be set to 80211b.

When the radio type is set to dot11b or dot11g, the function of denying access from non-HT STAs becomes invalid.

If WDS- or Mesh-enabled radios are configured not to support 802.11n/ac, the air interface backhaul performance will be degraded.

If you run the radio-type dot11b command in the 2G radio profile view to set the radio type to dot11b, and the 2G radio profile is applied to an AP, the rates of Beacon frames and multicast packets that take effect on the 2 GHz radio of the AP are fixed as 1 Mbps, and the values configured using the beacon-2g-rate beacon-2g-rate and multicast-rate multicast-rate commands do not take effect on the AP.

Example

# Set the radio type to dot11g in a 2G radio profile.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] radio-2g-profile name default
[HUAWEI-wlan-radio-2g-prof-default] radio-type dot11g
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 114557

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next