No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
slave-slot

slave-slot

Function

The slave-slot command specifies a slave X series interface card for a WLAN work group.

The undo slave-slot command deletes a slave X series interface card from a WLAN work group.

By default, no slave X series interface card is configured for a WLAN work group.

Format

slave-slot slave-slot-id

undo slave-slot

Parameters

Parameter Description Value
slave-slot-id Specifies the slot ID of the slave X series interface card in a WLAN work group.
  • On a standalone switch where CSS is not enabled, slave-slot-id is an integer and must be set according to the device configuration.
  • In a CSS, slave-slot-id is in the format cluster ID/slot ID, for example, 1/2.

Views

WLAN work group

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can use this command to add or modify a slave X series interface card in a WLAN work group. After a slave X series interface card is configured, the two X series interface cards work in hot backup mode. When the master X series interface card fails, the slave X series interface card undertakes ongoing WLAN services. When the master card recovers, WLAN services are not switched back until the slave card becomes faulty.

Precautions

Each WLAN work group can contain only one slave X series interface card.

Maximum numbers of supported users and APs must be the same on both X series cards.

Before modifying a slave X series interface card, run the state block command to set the WLAN work group in block state. After that, run the ap-reset work-group and cut access-user work-group commands to force APs and STAs offline.

Example

# Add the slave X series interface card in slot 2 to the WLAN work group 1.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] wlan work-group 1
[HUAWEI-wlan-work-group1] slave-slot 2
Related Topics
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 124828

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next