No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display ap power-workmode

display ap power-workmode


The display ap power-workmode command displays the current power mode of APs.


display ap power-workmode { all | ap-name ap-name | ap-id ap-id | ap-mac ap-mac | ap-group ap-group }






Displays the current power mode of all APs.


ap-name ap-name

Displays the current power mode of the AP with a specified name.

The AP name must exist.

ap-id ap-id

Displays the current power mode of the AP with a specified ID.

The AP ID must exist.

ap-mac ap-mac

Displays the current power mode of the AP with a specified MAC address.

The AP's MAC address must exist.

ap-group ap-group

Displays the current power mode of APs in a specified AP group.

The AP group must exist.


All views

Default Level

1: Monitoring level

Usage Guidelines

When an AP is supplied with DC or PoE power, the AP may work in low-power mode if the power fails to meet requirements. You can run this command to view the current power mode of the AP and verify that the current power mode can enable the AP to work with all functions.


# Display the current power mode of all APs.

<HUAWEI> display ap power-workmode all
ID     MAC              Name    Group     Power-workmode     Decided by
0     dcd2-fcf6-76a0    ap_1    default   AT(FULL)           LLDP 
Total: 1
Table 11-27  Description of the display ap power-workmode command output
Item Description




AP MAC address.


AP name.


AP group to which an AP belongs.


Current power mode of an AP.
  • The power mode of an AP can be AF, AT, or BT, which represents 802.3af, 802.3at, or 802.3bt, respectively.
  • The working mode of an AP can be Full, Limited, or Disabled. In Full mode, functions of the AP are unrestricted. In Limited mode, functions of the AP are partially restricted. In Disabled mode, the AP restarts due to insufficient power supply, and you are not advised to use the AP in this mode.

Decided by

The current power mode of an AP is determined by:
  • LLDP: LLDP negotiation result
  • Hardware detect: hardware detection result
  • AP capability: its own highest capability
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127130

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next