No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
fwa wmm edca-mode

fwa wmm edca-mode

Function

The fwa wmm edca-mode command sets the Enhanced Distributed Channel Access (EDCA) mode.

By default, the automatic EDCA mode is used.

Format

fwa wmm edca-mode { auto | manual }

Parameters

Parameter

Description

Value

auto

Sets the EDCA mode to auto.

In automatic EDCA mode, ATs automatically adjust EDCA parameters based on the number of ATs connecting to the remote AP.

-

manual

Sets the EDCA mode to manual.

In manual mode, you can run the fwa wmm edca-client command to configure EDCA parameters of the AT. The remote AP negotiates with the AT according to the configured parameters.

-

Views

Mesh profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

In scenarios where the AT connects to the remote AP through Mesh links, ATs automatically adjust EDCA parameters based on the number of ATs connecting to the remote AP.In manual mode, you can run the fwa wmm edca-client command to configure EDCA parameters of the AT. The remote AP negotiates with the AT according to the configured parameters.

NOTE:
  • The fwa wmm edca-mode command takes effect only after the FWA mode is enabled in the Mesh profile using the fwa enable command.
  • In automatic EDCA mode, the EDCA parameters manually configured using the fwa wmm edca-client command do not take effect on the AP.
  • This command applies only to scenarios where the AT connects to the remote AP through Mesh links.

Example

# Set the EDCA mode to auto.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] mesh-profile name huawei
[HUAWEI-wlan-mesh-prof-huawei] fwa wmm edca-mode auto
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127688

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next