No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
fwa enable

fwa enable

Function

The fwa enable command enables FWA for a Mesh profile.

The undo fwa enable command disables FWA for a Mesh profile.

By default, FWA is disabled for a Mesh profile.

Format

fwa enable

undo fwa enable

Parameters

None

Views

Mesh profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

An outdoor Access Terminal (AT) needs to set up a Mesh link with a remote AP to provide network access for the connected users. You need to configure Mesh service on the remote AP and enable Fixed Wireless Access (FWA) in the Mesh profile so that the AT can connect to the remote AP.

Configuration Impact

  • FWA and vehicle-ground fast link handover are mutually exclusive in a Mesh profile.

  • After you enable FWA for a Mesh profile using the fwa enable command, the default value of link-num in the max-link-number link-num command is 32, and the value ranges from 1 to 32.

  • After you enable FWA in a Mesh profile using the fwa enable command, the RSSI threshold of a Mesh link is fixed as -90 dBm, and not changed by the link-rssi-threshold command.

  • After you enable FWA in a Mesh profile using the fwa enable command, you can complete Mesh service configuration without the need to bind a Mesh whitelist profile to the Mesh profile.

  • After you enable FWA for a Mesh profile using the fwa enable command, the radio bound to the Mesh profile allows access from only ATs. Do not enable FWA when ATs are not used to prevent a Mesh service configuration failure.

Example

# Enable FWA for the Mesh profile named test.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] mesh-profile name test
[HUAWEI-wlan-mesh-prof-test] fwa enable
# Disable FWA for the Mesh profile named test.
<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] mesh-profile name test
[HUAWEI-wlan-mesh-prof-test] undo fwa enable
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126471

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next