No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
protect-ac

protect-ac

Function

The protect-ac command configures the standby AC's IP address in the AP system profile view.

The undo protect-ac command restores the standby AC's IP address to the default setting in the AP system profile view.

By default, no standby AC's IP address is configured in the AP system profile view.

Format

protect-ac ip-address ip-address

undo protect-ac

Parameters

Parameter

Description

Value

ip-address ip-address

Specifies an IPv4 address for the standby AC.

The value is in dotted decimal notation.

Views

AP system profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

To connect an AP to two ACs (active and standby ACs) to implement dual-link backup, you can run the protect-ac command to configure the standby AC's IP address in the AP system profile view.

Precautions

If standby AC's IP addresses are configured in both the WLAN view and AP system profile view, the standby AC's IP address configured in the AP system profile view is delivered to an AP. If no standby AC's IP address is configured in the AP system profile view, the standby AC's IP address configured in the WLAN view is delivered to an AP.

The IP address of the standby AC cannot be specified as the IP address of the local device. Otherwise, the backup function does not take effect.

Example

# Set the standby AC's IP address to 10.3.3.3 in the AP system profile view.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name ap-system1
[HUAWEI-wlan-ap-system-prof-ap-system1] protect-ac ip-address 10.3.3.3
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 114169

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next