No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
security-profile (WDS profile view)

security-profile (WDS profile view)


The security-profile command binds a security profile to a WDS profile.

The undo security-profile command restores the default security profile bound to a WDS profile.

By default, the security profile default-wds is bound to a WDS profile.


security-profile profile-name

undo security-profile






Specifies the name of the security profile bound to a WDS profile.

The security profile must exist.


WDS profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Before a WDS profile is applied to an AP radio to set up WDS links, the WDS profile must have a security profile bound to ensure WDS link security.


After a security profile is bound to a WDS profile, the authentication policy and encryption mode in the security profile cannot be changed, but the authentication key can be changed.

A WDS profile can only have one security profile bound. If you run the command multiple times in the same WDS profile view, the latest configuration overwrites the old one.


# Create the security profile sec and set the security policy to WPA2+PSK+AES. Create the WDS profile test and bind the security profile to the WDS profile.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] security-profile name sec
[HUAWEI-wlan-sec-prof-sec] security wpa2 psk pass-phrase huawei@123 aes
[HUAWEI-wlan-sec-prof-sec] quit
[HUAWEI-wlan-view] wds-profile name test
[HUAWEI-wlan-wds-prof-test] security-profile sec
Warning: This action may cause service interruption. Continue?[Y/N]y
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 123932

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next