No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The ap-reset command resets an AP.


ap-reset { all | ap-name ap-name | ap-mac ap-mac | ap-id ap-id | ap-group ap-group | ap-type { type type-name | type-id type-id } }






Resets all APs.


ap-name ap-name

Resets the AP with the specified AP name.

The AP name must exist.

ap-mac ap-mac

Resets the AP with the specified MAC address.

The AP's MAC address must exist.

ap-id ap-id

Resets the AP with the specified AP ID.

The AP ID must exist.

The value is a string of 1 to 255 characters. When multiple APs are selected, use commas (,) or hyphens (-) to separate AP IDs. For example, 5,8,10-13,20 indicates the list of APs with IDs 5, 8, 10, 11, 12, 13, and 20.

ap-group ap-group

Resets APs in the specified AP group.

The AP group must exist.


Resets APs of the specified AP type.


type type-name

Resets APs of the specified type name.

The AP type name must exist.

type-id type-id

Resets APs of the specified type ID.

The AP type ID must exist.


WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After in-service upgrade of APs is complete, you can run the ap-reset command to reset the APs. After the command is run, the APs restart with the upgraded software version. You can also use the command to restart APs for other reasons.


An AP exists on the AC.


# Reset the AP N1-2.
<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-reset ap-name N1-2
Warning: Reset AP(s), continue?[Y/N]:y
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126563

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next