No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
user-isolate (AP wired port profile view)

user-isolate (AP wired port profile view)

Function

The user-isolate command enables user isolation on an AP's wired interface.

The undo user-isolate command disables user isolation on an AP's wired interface.

By default, user isolation is disabled on an AP's wired interface.

Format

user-isolate { all | l2 }

undo user-isolate

Parameters

Parameter

Description

Value

all

Enables Layer 2 and Layer 3 user isolation.

-

l2

Enables Layer 2 user isolation.

-

Views

AP wired port profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The user isolation function prevents users on the same wired interface from communicating with each other. All user traffic on the wired interface is forwarded by the gateway. Therefore, this function ensures communication security on wired interfaces and allows uniform charging for users.

Precautions

Eth-Trunk member interfaces do not support the user isolation function.

The AP's wired interface has been configured to work in endpoint or middle mode.

Example

# Set the working mode of the AP's wired interface GE0 to endpoint and enable Layer 2 user isolation on GE0.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-group name ap-group1
[HUAWEI-wlan-ap-group-ap-group1] quit
[HUAWEI-wlan-view] wired-port-profile name wired
[HUAWEI-wlan-wired-port-wired] mode endpoint
Warning: If the AP goes online through a wired port, the incorrect port mode configuration will cause the AP to go out of management
. This fault can be recovered only by modifying the configuration on the AP. Continue? [Y/N]:y
[HUAWEI-wlan-wired-port-wired] user-isolate l2
[HUAWEI-wlan-wired-port-wired] quit
[HUAWEI-wlan-view] ap-group name ap-group1
[HUAWEI-wlan-ap-group-ap-group1] wired-port-profile wired gigabitethernet 0
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 115746

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next