No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
wlan work-group

wlan work-group

Function

The wlan work-group command creates a WLAN work group and displays the WLAN work group view, or displays the view of an existing WLAN work group.

The undo wlan work-group command deletes a WLAN work group.

By default, a default WLAN work group exists and cannot be deleted.

Format

wlan work-group { group-id | default }

undo wlan work-group group-id

Parameters

Parameter Description Value
group-id Specifies the WLAN work group ID. The value is an integer ranging from 1 to 4.
default Indicates the default WLAN work group.

-

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

If APs cannot access the AC through an X series interface card, add the X series interface card and non-X series interface cards into the same WLAN work group so that the APs can access the AC through the non-X series interface card and the AC can manage the APs normally.

Interface cards on the AC automatically join the default WLAN work group. Therefore, the centralized AC function can still be implemented when no WLAN work group is configured on the AC. If more than two X series interface cards exist on the AC, the first detected card is regarded as the master and the second as the slave. You are advised to configure a WLAN work group and add redundant X series interface cards to the WLAN work group to implement the centralized AC function, which improves resource usage efficiency and enables more traffic transmitting.

Precautions

A WLAN work group contains at least one X series interface card and one non-X series interface card.

Before deleting a WLAN work group, run the state block command to set the WLAN work group in block state. After that, run the ap-reset work-group and cut access-user work-group commands to force APs and STAs offline.

Example

# Create WLAN work group 1 and enter the WLAN work group view.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] wlan work-group 1
[HUAWEI-wlan-work-group1] 
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 113067

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next