No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
mesh-whitelist-profile (AP group radio view or AP radio view)

mesh-whitelist-profile (AP group radio view or AP radio view)


The mesh-whitelist-profile command binds a Mesh whitelist profile to an AP radio.

The undo mesh-whitelist-profile command unbinds a Mesh whitelist profile from an AP radio.

By default, no Mesh whitelist profile is bound to an AP radio.


mesh-whitelist-profile whitelist-name

undo mesh-whitelist-profile






Specifies the name of the Mesh whitelist profile bound to an AP radio.

The Mesh whitelist profile must exist.


AP group radio view, AP radio view

Default Level

2: Configuration level

Usage Guidelines

After a Mesh whitelist profile is applied to an AP radio, the AP radio can only set up Mesh links with neighboring APs whose MAC addresses are in the Mesh whitelist profile.

On a Mesh network where ATs are deployed, after FWA is enabled in a Mesh profile using the fwa enable command, you can complete the Mesh service configuration without the need to bind a Mesh whitelist profile to an AP radio. However, in other Mesh application scenarios, an AP radio must have a Mesh whitelist profile bound, and the Mesh whitelist profile must have MAC addresses configured.

An AP radio can only have one Mesh whitelist profile bound. If you run the command multiple times on the same AP radio, the latest configuration overwrites the old one.

On a triple-radio AP, radio 2 does not support the Mesh function.


# Create the Mesh whitelist profile whitelist and add the MAC address 0001-0001-0001 to the whitelist profile. Bind the Mesh whitelist profile whitelist to radio 0 of APs in the AP group group1.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] mesh-whitelist-profile name whitelist
[HUAWEI-wlan-mesh-whitelist-whitelist] peer-ap mac 0001-0001-0001
[HUAWEI-wlan-mesh-whitelist-whitelist] quit
[HUAWEI-wlan-view] ap-group name group1
[HUAWEI-wlan-ap-group-group1] radio 0
[HUAWEI-wlan-group-radio-group1/0] mesh-whitelist-profile whitelist
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127039

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next