No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
spectrum-analysis source

spectrum-analysis source

Function

The spectrum-analysis source command configures the source IP address of packets sent by an AC to a spectrum server.

The undo spectrum-analysis source command deletes the configured source IP address of packets sent by an AC to a spectrum server.

By default, an AC uses the IP address of the outbound interface on the matched route as the source IP address of packets sent to a spectrum server.

Format

spectrum-analysis source ip-address ip-address

undo spectrum-analysis source

Parameters

Parameter

Description

Value

ip-address ip-address

Specifies the source IPv4 address of packets sent by an AC to a spectrum server.

The value is in dotted decimal notation.

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

By default, when sending data packets to a spectrum server, an AC uses the IP address of the outbound interface on the matched route between them to communicate with the spectrum server.

After the source IP address is configured using the spectrum-analysis source command, the AC uses this IP address to communicate with the spectrum server.

Precautions

  • Ensure that the AC IP address manually configured on the spectrum server is the same as that configured using the spectrum-analysis source command.
  • The source IP address must exist on the AC; otherwise, the configuration does not take effect.
  • The configured source IP address and the IP address of the spectrum server must be routable to each other.

Example

# Configure 10.102.25.23 as the source IP address of packets sent by the AC to a spectrum server.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] spectrum-analysis source ip-address 10.102.25.23
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127750

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next