No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
mu-mimo disable

mu-mimo disable


The mu-mimo disable command disables MU-MIMO.

The undo mu-mimo disable command enables MU-MIMO.

By default, the MU-MIMO function is enabled.


mu-mimo disable

undo mu-mimo disable




SSID profile view, WDS profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Carrier sense multiple access with collision avoidance (CSMA-CA) allows an air interface channel to be occupied only by one STA, and other STAs cannot communicate with the AP. After MU-MIMO is enabled, STAs supporting MU-MIMO can form an MU group to simultaneously receive downlink data from the same air interface channel, improving channel efficiency and overall downlink throughput.


  • Only the 802.11ac wave2 APs support MU-MIMO on 5 GHz radios.

  • In WDS scenarios, ensure that the number of spatial streams on STA VAPs is smaller than that on AP VAPs. Otherwise, MU-MIMO cannot take effect. For example, if STA VAPs and AP VAPs are both configured with three spatial streams, an AP VAP can communicate with only one STA VAP even if MU-MIMO has been enabled.

  • MU-MIMO is not supported on a Mesh network.


# Enable MU-MIMO in the SSID profile test.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ssid-profile name test
[HUAWEI-wlan-ssid-prof-test] undo mu-mimo disable
Related Topics
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126486

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next