No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
learn-client-address disable

learn-client-address disable


learn-client-address disable command disables STA IPv4/IPv6 address learning.

undo learn-client-address disable command disables STA IPv4/IPv6 address learning.

By default, STA address learning is enabled.


learn-client-address { ipv4 | ipv6 } disable

undo learn-client-address { ipv4 | ipv6 } disable


Parameter Description
ipv4 IPv4 address.
ipv6 IPv6 address.


VAP profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

If a STA associates with an AP that has STA address learning enabled and obtains an IP address, the AP automatically reports the STA IP address to the AC to maintain the STA' IP address and MAC address binding entry



  • The device enabled with STA address learning can learn only a limited number of IPv6 addresses; therefore, you are advised to configure only one IPv6 prefix for the IPv6 gateway. If you configure too many IPv6 prefixes, the number of IPv6 addresses exceeds the upper limit, and extra IPv6 addresses cannot be learnt by the device. The IPv6 addresses not learnt by the device cannot be used for communications.

  • If a bridging device functions as a STA to connect to an AP enabled with STA address learning, the AP cannot learn IP addresses of users connected to the bridging device; therefore, the users cannot communicate with the network. In this situation, disable STA address learning.

  • Disabling STA address learning will lead to a Portal authentication failure.


# Disable STA IPv4 address learning.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] vap-profile name vap1
[HUAWEI-wlan-vap-prof-vap1] learn-client-address ipv4 disable
Related Topics
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 113943

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next