No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display mac-address { ap-id | ap-name }

display mac-address { ap-id | ap-name }

Function

The display mac-address { ap-id | ap-name} command displays all dynamic, dynamic secure, and sticky MAC address entries from an AP's wired interface.

Format

display mac-address { ap-id ap-id | ap-name ap-name } interface-type interface-number

Parameters

Parameter

Description

Value

ap-id ap-id

Displays all dynamic, dynamic secure, and sticky MAC address entries on wired interfaces of the AP with the specified ID.

The AP ID must exist.

ap-name ap-name

Displays all dynamic, dynamic secure, and sticky MAC address entries on wired interfaces of the AP with the specified name.

The AP name must exist.

interface-type interface-number
Displays all dynamic, dynamic secure, and sticky MAC address entries on a specified interface.
  • interface-type specifies the interface type.
  • interface-number specifies the number of the outbound interface.
The following types of outbound interfaces are supported:
  • Eth-Trunk
  • Ethernet
  • Gigabitethernet
  • MultiGE

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

You can run the display mac-address { ap-id | ap-name} command to check all dynamic, dynamic secure, and sticky MAC address entries on an AP's wired interface, including the MAC addresses and VLANs that the AP learns on specified interfaces.

Example

# Display all dynamic, dynamic secure, and sticky MAC address entries on wired interfaces of the AP with ID 1.

<HUAWEI> display mac-address ap-id 1 ethernet 0
---------------------------------------------------------- 
MAC Address    VLAN/VSI   Learned-From        Type       
----------------------------------------------------------
1051-7254-5a80 1/-        Ethernet0/0/0       dynamic 
----------------------------------------------------------
Total: 1 
Table 11-58  Description of the display mac-address ap-id ap-id interface-type interface-number command output

Item

Description

MAC Address MAC address.
VLAN/VSI VLAN or VSI to which the device belongs.
Learned-From Interface on which the MAC address is learned.
Type Type of a MAC address entry.
Related Topics
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 116964

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next