No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
stp enable (AP wired port profile view)

stp enable (AP wired port profile view)


The stp enable command enables STP on an AP's wired interface.

The undo stp enable command disables STP on an AP's wired interface.

By default, STP is disabled on an AP's wired interface.


stp enable

undo stp enable




AP wired port profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run this command to prevent or eliminate loops on a complex Layer 2 network. STP on the AP's wired interfaces takes effect only when the AP forms a single loop with wired devices. An STP-enabled AP does not forward STP packets to the wireless side. STP takes effect only on the AP's wired side.


If an AP's wired interface is added to an Eth-Trunk, the wired interface does not support STP.


# Enable STP on the AP's wired interface GE0.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-group name ap-group1
[HUAWEI-wlan-ap-group-ap-group1] quit
[HUAWEI-wlan-view] wired-port-profile name wired
[HUAWEI-wlan-wired-port-wired] stp enable
[HUAWEI-wlan-wired-port-wired] quit
[HUAWEI-wlan-view] ap-group name ap-group1
[HUAWEI-wlan-ap-group-ap-group1] wired-port-profile wired gigabitethernet 0
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 123514

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next