No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ap-mac

ap-mac

Function

The ap-mac command adds an AP offline or displays the AP view.

By default, no AP is added offline.

Format

ap-mac ap-mac [ type-id type-id | ap-type ap-type ] [ ap-id ap-id ] [ ap-sn ap-sn ]

Parameters

Parameter

Description

Value

ap-mac

Specifies the MAC address of an AP.

The value is in H-H-H format. An H is a hexadecimal number of 4 digits.

type-id type-id

Specifies the AP type ID.

The value is an integer that ranges from 0 to 255.

ap-type ap-type

Specifies the AP type.

The value is a string of 1 to 31 characters.

ap-id ap-id

Specifies the AP ID.

The value is an integer. The value range varies according to devices:
  • S12704, S12708, and S12712 (The main control unit is MPUA): 0 to 6143
  • S12704, S12708, and S12712 (The main control unit is MPUD): 0 to 10239
  • S12710: 0 to 6143

ap-sn ap-sn

Specifies the sequence number (SN) of an AP.

The value is a string of 1 to 31 characters, and can only contain letters and digits.

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After an AP is successfully added to an AC, you can configure parameters for the AP offline. When the AP goes online, it uses the configured parameters.

Precautions

When adding an AP, you need to enter the MAC address of the AP. If the AP authentication mode is SN authentication, you also need to enter the SN of the AP.

To enter the AP view, you only need to enter the MAC address of the AP. If the entered MAC address does not exist, the system adds a new AP and displays the AP view.

The ap-mac ap-mac [ type-id type-id | ap-type ap-type ] [ ap-id ap-id ] [ ap-sn ap-sn ] and ap-id ap-id [ [ type-id type-id | ap-type ap-type ] { ap-mac ap-mac | ap-sn ap-sn | ap-mac ap-mac ap-sn ap-sn } ] commands have the same function. You can use either one according to the actual situation.

Example

# Add the AP with the MAC address 0025-9e07-8260.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-mac 0025-9e07-8260
Related Topics
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 114004

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next