No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
keep-service enable

keep-service enable

Function

The keep-service enable command configures the AP to continue providing data services after the CAPWAP link between the AP and AC is disconnected.

The undo keep-service enable command restores the default setting.

By default, all services on the AP are interrupted after the CAPWAP link between the AP and AC is disconnected.

Format

keep-service enable

undo keep-service enable

Parameters

None

Views

AP system profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

In direct forwarding mode, you can run the keep-service enable command to configure the AP to continue providing data services after the CAPWAP link between the AP and AC is disconnected. The data services then no longer depend on the CAPWAP link, which enhances service forwarding robustness.

Precautions

The command does not take effect on a WDS network.

The offline management VAP function and service holding upon CAPWAP link disconnection are mutually exclusive. When the two functions are configured at the same time, the offline management VAP function cannot take effect.

After this command is executed, if the wids device detect enable and wids contain enable commands are configured to enable device detection and containment, the AP will continue providing data services after going offline. However, the AC considers the AP as a rogue or interference device and adds it to the containment list. The containment mechanism will disconnect STAs from the AP. Therefore, service holding upon CAPWAP link disconnection does not take effect in this case.

Example

# Configure the AP to continue providing data services after the CAPWAP link between the AP and AC is disconnected.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name ap-system1
[HUAWEI-wlan-ap-system-prof-ap-system1] keep-service enable
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127973

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next