No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
mesh-profile (AP group radio view or AP radio view)

mesh-profile (AP group radio view or AP radio view)


The mesh-profile command binds a Mesh profile to an AP radio.

The undo mesh-profile command unbinds a Mesh profile from an AP radio.

By default, no Mesh profile is bound to an AP radio.


mesh-profile profile-name

undo mesh-profile






Specifies the name of the Mesh profile bound to an AP radio.

The Mesh profile must exist.


AP group radio view, AP radio view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After a Mesh profile is bound to an AP group radio or an AP radio, a Mesh VAP will be generated on the specified AP radio to provide Mesh services for users.


A Mesh profile has been created and properly configured.


Among the VAPs created after a Mesh profile is bound to a radio, the VAP with the WLAN ID 16 cannot be occupied.

An AP radio can only have one Mesh profile bound.

On a triple-radio AP, radio 2 does not support the Mesh function.

This command has the same function as the mesh-profile radio command. You can use either of them.


# Bind the Mesh profile test to radio 0 of APs in the AP group group1.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-group name group1
[HUAWEI-wlan-ap-group-group1] radio 0
[HUAWEI-wlan-group-radio-group1/0] mesh-profile test
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 143176

Downloads: 92

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next