No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display mesh-handover-profile

display mesh-handover-profile

Function

The display mesh-handover-profile command displays reference or configuration information about a Mesh handover profile.

Format

display mesh-handover-profile { all | name profile-name }

Parameters

Parameter

Description

Value

all

Displays reference information about all Mesh handover profiles.

-

name profile-name

Displays information about a specified Mesh handover profile.

The Mesh handover profile must exist.

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

You can run the display mesh-handover-profile command to view the number of times a Mesh handover profile is referenced by a Mesh profile or parameter settings of a specified Mesh handover profile.

Example

# Display reference information about all Mesh handover profiles.

<HUAWEI> display mesh-handover-profile all
--------------------------------------------------------------------------------
Profile name                         Reference                                  
--------------------------------------------------------------------------------
default                              0                                          
test                                 2                                          
--------------------------------------------------------------------------------
Total: 2                                                                        
Table 11-233  Description of the display mesh-handover-profile all command output

Item

Description

Profile name

Name of a Mesh handover profile.

To create a Mesh handover profile, run the mesh-handover-profile command.

Reference

Number of times a Mesh handover profile is referenced by a Mesh profile.

# Display information about the Mesh handover profile test.

<HUAWEI> display mesh-handover-profile name test
--------------------------------------------------------------------------------
Handover location based algorithm switch            : disable                   
Handover probe interval(ms)                         : 100                    
--------------------------------------------------------------------------------
Table 11-234  Description of the display mesh-handover-profile name command output

Item

Description

Handover location based algorithm switch

Status of the location-based enhanced fast link handover algorithm.
  • disable: The algorithm is disabled.
  • enable: The algorithm is enabled.

To configure the parameter, run the location-based-algorithm enable command.

Handover probe interval

Mesh link probe interval.

To configure the parameter, run the link-probe-interval command.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126112

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next