No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ip-address (AP provisioning view)

ip-address (AP provisioning view)

Function

The ip-address command configures a static IPv4 address and gateway for an AP.

The undo ip-address command restores the default static IPv4 address and gateway for an AP.

By default, no static IPv4 address and gateway are configured for an AP.

Format

ip-address ip-address { mask-length | mask } [ gateway gateway ]

undo ip-address

Parameters

Parameter Description Value
ip-address Specifies the static IPv4 address for an AP.

The value is in dotted decimal notation.

mask Specifies the IPv4 address mask for an AP.

The value is in dotted decimal notation.

mask-length Specifies the IPv4 address mask length for an AP. The value is an integer that ranges from 0 to 32.
gateway gateway Specifies the egress gateway for AP routes.

The value is in dotted decimal notation.

Views

AP provisioning view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

To configure an AP to go online using a specified IPv4 address, run the command to configure a static IPv4 address for the AP.

Prerequisites

The AP has been configured to obtain an IP address in static mode using the address-mode (AP provisioning view) command.

Follow-up Procedure

Run the commit command to deliver configuration to APs and restart the APs to make the configuration take effect.

Precautions

Ensure that there are reachable routes between the configured IPv4 address and the AC source address for an AP to go online. Otherwise, the AP may fail to go online.

CAPWAP packets between the central AP and RUs are forwarded at Layer 2 and are independent of IP addresses on an agile distributed WLAN. Therefore, the configuration of a static IP address does not affect the RU going online. Ensure that a route is reachable between the IP address of the RU and the central AP source address. Otherwise, services involving IP addresses may be affected, for example, Telnet.

If the AP and AC are connected through a Layer-3 network, the egress gateway for AP routes must be configured.

Example

# Set the static IPv4 address of the AP to 10.1.1.1/24.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] provision-ap
[HUAWEI-wlan-provision-ap] address-mode static
[HUAWEI-wlan-provision-ap] ip-address 10.1.1.1 24
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127703

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next