No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Log Reference

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
L3AD

L3AD

L3AD/4/RESOURCE_FULL

Message

L3AD/4/RESOURCE_FULL: The resource of the table on the chip is not enough.(Type=[STRING])

Description

The entry resources of a chip are allocated, and the current resources are insufficient.

Parameters

Parameter Name Parameter Meaning
Type entry type of a chip, including:
  • L3INTF: layer-3 egress entry
  • L3EGRESS: next-hop entry
  • L3ECMP: next-hop group entry

Possible Causes

The usage of entry resources is beyond the range. It is recommended to release part of resources.

Procedure

  1. Perform the following operations based on the chip entry type in the alarm:

    If the number of Layer 3 egress entry resources is not enough, delete redundant VLANIF and tunnel interfaces.

    If the number of next-hop entry resources is not enough, shut down certain egresses.

    If the number of next-hop group entry resources is not enough, delete certain equivalent routes. In case of static routes, you can delete some unnecessary routes. In case of dynamic routes, you can run the maximum load-balancing command to reduce the maximum number of equal-cost routes.

  2. If the fault persists, collect log information and configuration information, and then collect log information and configuration information, and then contact technical support personnel.You can collect diagnostic information using the display diagnostic-information command.
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065665

Views: 5417

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next