No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PTP on an Interface

Configuring PTP on an Interface

Context

On an interface, you can enable PTP and configure the delay measurement mechanism, method to process Announce messages, and mode in which PTP messages carry timestamps.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ptp enable

    PTP is enabled on the interface.

    By default, PTP is disabled on an interface.
    NOTE:
    On the TC device, PTP must be enabled on the interfaces that receive and send PTP messages. Otherwise, the resident time of the device cannot be calculated correctly and only PTP messages are forwarded.

  4. (Optional) Run ptp tcoc-clock-id clock-source-id port-num port-num

    The clock source traced by an interface on the TCOC is specified.

    By default, no clock source is specified for a TCOC to trace. A TC only transmits clock signals but not synchronizes clock signals. To enable a device to synchronize one of multiple clock signals, configure the device as a TCOC and specify a clock trace for the device to trace.
    NOTE:
    This command takes effect only on a TCOC.

  5. (Optional) Run ptp clock-step { one-step | two-step }

    The mode in which PTP devices timestamp PTP messages to perform clock synchronization is configured.

    By default, PTP messages are timestamped in one-step mode.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 48684

Downloads: 424

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next