No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an AS in Centralized Mode (Direct Configuration)

Configuring an AS in Centralized Mode (Direct Configuration)


Service configurations can be delivered to ASs through service profiles. Apart from this method, you can also run the direct-command command on the parent to deliver some service configurations directly to ASs.

For services that can be directly configured for a single AS, see Service Configuration Supported on an AS.


  1. Run system-view

    The system view is displayed.

  2. Run uni-mng

    The uni-mng view is displayed.

  3. Run as name as-name

    The AS view is displayed.

  4. Run direct-command view { system | interface-type interface-number | stack-port member-id/port-id } command command-text

    A command is directly delivered to an AS.

Verifying the Configuration

  • Run the display uni-mng commit-result as-direct-config command to check the configuration delivery result.
  • Run the display uni-mng execute-failed-record as-direct-config as name as-name command to check execution failure records after the configuration is delivered to an AS.
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 77770

Downloads: 515

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next