No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Manual Clock Source Selection Mode

Configuring the Manual Clock Source Selection Mode

Context

By default, the switch uses the automatic clock source selection algorithm to determine the clock source to be traced. You can also manually specify the clock source to be traced based on the clock source quality.

In manual mode:
  • A manually specified clock source takes effect only when the clock source is in the normal or holdoff state and the SSM quality level of the clock source is the highest. To view the clock source status, run the display clock source command.
  • If a manually specified clock source becomes invalid, the switch works in automatic clock source selection mode. After the manually specified clock source is restored, the switch continues to use the automatic clock source selection mode, even after it is restarted.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run clock manual source { ptp slot slot-id | interface interface-type interface-number }

    The clock source to be traced is manually specified.

    By default, the system uses the automatic clock source selection algorithm to determine the clock source to trace.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 34209

Downloads: 287

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next