No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Active/Standby Switchover

Configuring Active/Standby Switchover

Context

If the master switch in a stack of member switches fails, manually perform an active/standby switchover. After the active/standby switchover is complete, the previous master switch joins the stack after restarting, and the previous standby switch becomes the new master switch.

Before performing an active/standby switchover, run the display switchover state command to check whether the system meets active/standby switchover requirements. During an active/standby switchover, ensure that the standby switch is in real-time backup state.

Procedure

  1. (Optional) Run display switchover state

    The active/standby switchover status is displayed. According to the status, determine whether the stack meets switchover requirements.

  2. Run system-view

    The system view is displayed.

  3. Run slave switchover enable

    Active/standby switchover is enabled.

    By default, the active/standby switchover function is enabled.

  4. Run slave switchover

    An active/standby switchover is performed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 51125

Downloads: 441

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next