No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the DC Output Function

Configuring the DC Output Function


If PDs require DC power supply, enable DC output on the switch.


Only the S5720I-10X-PWH-SI-AC supports this function.


  1. Run system-view

    The system view is displayed.

  2. Run set device dc-output [ 12V [ line1 | line2 ] | 24V ] enable

    The DC output function is enabled.

    By default, the DC output function is enabled on a switch.

Verifying the Configuration

Run the display device dc-output status command to display DC output status of the switch.

Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 41525

Downloads: 356

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next