No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Event Reporting Delay Function

Configuring the Event Reporting Delay Function

Context

The event reporting delay function prevents events from being reported repeatedly. After the event reporting delay function is enabled and the period of delay is configured, the system discards the event that is generated several times during the delay. When the delay expires, the system reports the only first event.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run event

    The event view is displayed.

  3. Run delay-suppression enable

    The event reporting delay function is enabled.

    By default, the event reporting delay function is enabled.

  4. (Optional) Run display event information [ name event-name ]

    The period of delay in reporting events is displayed.

  5. (Optional) Run suppression event-name event-name period seconds

    The period of delay in reporting events is configured.

    The system has defined a default period of delay in reporting events.

    NOTE:

    Run the undo suppression event-name and display event information commands in sequence to view the default period of reporting delay.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 37698

Downloads: 330

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next