No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between Monitoring Interfaces and the NMS

Configuring Association Between Monitoring Interfaces and the NMS

Context

The switch monitors status changes of input lines, generates a trap, and reports the trap to the NMS. For example, if the normal status of monitoring interfaces is set to the low level, and the input line is in high level, the switch sends a fault trap. When the input line returns to the low level, the switch sends a clear trap.

Pre-configuration Tasks

The switch can send traps to the NMS. For details, see "SNMP Configuration" in the S2720, S5700, and S6720 V200R013C00 Configuration Guide - Network Management.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the monitor input line-id enable command to enable the input line monitoring function for monitoring interfaces.

    By default, the input line monitoring function is disabled for monitoring interfaces.

  3. Run the monitor input line-id name line-name normal-state { low-level | high-level } command to set input line names and the level of the input line in normal state.

    By default, input lines of monitoring interfaces are Input1 and Input2, and the level of the input lines in normal state is low-level.

Verifying the Configuration

Run the display monitor input { line-id | all } command to check the input line status.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 50480

Downloads: 435

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next