No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring G.8275.1 Globally

Configuring G.8275.1 Globally

Context

TO configure G.8275.1 globally, enable it in the system view and set the device type to T-BC. Perform the following operations on T-BC:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ptp enable

    PTP is enabled.

    By default, PTP is not enabled.

  3. Run ptp profile g-8275-1 enable

    ITU-T G.8275.1 is used.

    By default, PTP configuration complies with IEEE 1588v2.

  4. Run ptp device-type t-bc slot slot-id

    The device type is configured as T-BC.

    By default, no device type is configured for a PTP device.

  5. (Optional) Run ptp domain domain-value

    The domain to which the PTP device belongs is configured.

    By default, a PTP device belongs to domain 0.

    NOTE:
    Devices that perform clock synchronization through G.8275.1 messages must belong to the same PTP domain.

  6. (Optional) Run ptp virtual-clock-id clock-id-value slot slot-id

    A virtual clock ID is set for T-BC.

    By default, no virtual clock ID is configured for a PTP device. In this case, the system automatically generates clock IDs based on device MAC addresses. You can manually configure a virtual clock ID to identify a PTP device.

    NOTE:

    Ensure that the virtual clock ID configured using the ptp virtual-clock-id command is unique in the entire PTP domain.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 33891

Downloads: 285

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next