No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Deep Power Saving Mode

Configuring the Deep Power Saving Mode

Context

The device enters the sleeping mode when the following conditions are met:
  • The device works in deep mode. By default, the standard energy-saving mode is used.
  • A time range applies to the device in sleeping mode.
  • During the period for continuously detecting awakening port status, the terminals (switches or PCs) connected to awakening ports are shut down.
    NOTE:

    If the terminal is a PC, the device can enter the dormancy state only when the PC is shut down and its network adapter is powered off (this can be set in the power management module of BIOS).

The device is awakened when either of the following conditions is met:
  • A user logs in to the device through the serial port and presses Ctrl+W.
  • The terminals (switches or PCs) connected to awakening ports are started up.
  • The sleeping time range expires (if a time range is configured).
  • A user presses the mode switching button.

After a switch enters the sleeping mode, you can log in to the switch through its serial port and press Ctrl+\ to check the remaining sleeping time.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run set power manage mode 4

    The power saving mode is set to deep mode.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 44338

Downloads: 372

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next