No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring 1588v2 on a TCandBC

Configuring 1588v2 on a TCandBC

TCandBC Deployment

In Figure 14-17, all devices on the bearer network and NodeBs support 1588v2. CarrierA has NodeBs and an external clock source2, but does not have bearer network devices. CarrierB leases its bearer network to CarrierA. Devices on the bearer network synchronize with the external clock source1 of CarrierB. To ensure that clock synchronization is implemented independently on devices of CarrierA and CarrierB, you can deploy the network as follows:
  • BC1 and OC1 connect to clock1 and clock2 respectively, and send clock synchronization information to downstream devices through 1588v2 messages.
  • TCandBC1 directly connects to BC1 through a BC interface and participates in clock synchronization in Domain 1. The user-side interface of TCandBC1 is a TC interface.
  • TCandBC2 directly connects to BC1 through a BC interface and participates in clock synchronization in Domain 1. The user-side interface of TCandBC2 is a TC interface.
  • Interfaces that directly connect TCandBC2 to OC2, TCandBC2 to TCandBC1, and TCandBC1 to OC1 provide the TC function. OC2 receives 1588v2 messages sent from TCandBC1 through the PW channel between TCandBC1 and TCandBC2, synchronizes clock information with TCandBC1, and then sends clock information to NodeB using traditional synchronization methods such as synchronous Ethernet.
  • The bearer network has two PTP domains: Domain 1 and Domain 2. All devices in Domain 1 function as BCs to implement PTP synchronization and transmit messages between TCandBC1 and TCandBC2. For Domain 2, the entire bearer network functions as a large TC, which transparently transmits clock2 information to NodeB.
Figure 14-17  Configuring 1588v2 on a TCandBC

Pre-configuration Tasks

Before configuring 1588v2 on a TCandBC, complete the following tasks:

  • Set link layer protocol parameters for interfaces to ensure that the link layer protocol status of the interfaces is Up.

  • Ensure that the OC1 and OC2 correctly receive clock and time signals from the clock.

  • Configure synchronous Ethernet to synchronize the clock frequency on the network.

Configuration Procedure

The process of configuring 1588v2 on a TCandBC is as follows.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 34560

Downloads: 291

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next