No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for PTP

Licensing Requirements and Limitations for PTP

Involved Network Elements

None

Licensing Requirements

PTP is a basic feature of a switch and is not under license control.

Version Requirements

Only the S6720HI series switches support PTP.

Feature Limitations

PTP Constraints

  • All the intermediate devices on the PTP synchronization path must support PTP.
  • Frequency signals are transmitted bidirectionally, and time signals are transmitted unidirectionally. For frequency signals, a crossover cable is required; for time signals, a straight-through cable is required.
  • PTP Announce messages contain the clock attributes of the peer device to establish the master-slave hierarchy of interfaces. Therefore, prohibit a PTP interface from receiving Announce messages from different devices.

PTP Precautions

NOTE:

Before configuring PTP for time synchronization, ensure frequency synchronization on the entire network. To implement frequency synchronization, configure synchronous Ethernet. This chapter describes only PTP time synchronization. For details about how to configure PTP for frequency synchronization, see "Synchronous Ethernet Configuration" in Device Management.

  • PTP messages are Layer 2 broadcast messages by default. If incorrect configuration is performed, loops or broadcast storms occur and downstream devices are seriously affected. To avoid broadcast storms or loops, configure VLAN or STP before enabling PTP on an interface.
  • By default, a device obtains frequency signals through synchronous Ethernet and obtains time signals through PTP. When PTP is used for clock synchronization, you are advised to configure the device to obtain frequency signals and time signals through PTP.
  • The switch supports PTP only after its working mode has been set to enhanced mode using the set service-mode command.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 48591

Downloads: 424

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next