No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
S5700HI and S5710HI Service Port Stacking Support

S5700HI and S5710HI Service Port Stacking Support

NOTE:
  • For the cables that can be used as stack cables, see "Cables" in the Hardware Description. Using other cables may cause exceptions in the stack system, for example, frequent error-down events on stack ports.
  • Combo ports cannot function as stack member ports.
  • For stacking-supported service ports, some of them can be used as stack ports, whereas some can be used as ordinary service ports.
  • The number of stacked switches is recommended to be 2 to 5.
Table 3-9  Service port stacking support

Device Series

Port Supporting Stacking Stack Cable Rate of a Single Port

Remarks

S5700HI

10GE ports on front cards: The S5700HI supports ES5D00X2SA00 and ES5D00X4SA00 front cards, which support two and four 10GE SFP+ optical ports respectively.
  • 1 m and 3 m SFP+ passive high-speed copper cables
  • 10 m SFP+ active high-speed copper cables
  • 3 m and 10 m AOC cables
  • 10GE SFP+ optical module and optical fiber

10 Gbit/s

  • Any models of the S5700HI series can set up a stack.
  • A switch supports a maximum of two logical stack ports, and each logical stack port supports at least one stack member port and at most four stack member ports. A switch supports a maximum of four stack member ports.
  • After a front card is replaced by a card of a different type, the stack configurations become ineffective and need to be performed again.
S5710HI 8*10GE ports on the front panel
  • 3 m and 10 m AOC cables
  • 10GE SFP+ optical module and optical fiber
10 Gbit/s
  • Any models of the S5710HI series can set up a stack.
  • A switch supports a maximum of two logical stack ports, and each logical stack port supports at least one stack member port and at most four stack member ports. Each switch can use a maximum of eight service ports as stack member ports.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 48709

Downloads: 426

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next