No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Local Source Interface for Sending and Receiving NTP Packets

Configuring the Local Source Interface for Sending and Receiving NTP Packets

Prerequisites

All basic NTP functions have been configured.

NOTE:

If the ntp-service unicast-server or the ntp-service unicast-peer command specifies the source interface of NTP packets, the specified source interface takes effect.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ntp-service [ ipv6 ] source-interface interface-type interface-number [ vpn-instance vpn-instance-name ]

    The local source interface for sending and receiving NTP packets is configured.

    By default, the local source interface for sending NTP packets is not specified. The source IP address of an NTP packet is selected based on route.

    In manycast, broadcast and multicast modes, the NTP service is performed on the source interface and the ntp-service source-interface command does not take effect.

    If the specified NTP source interface is in Down state, the source IP address of a sent NTP packet is the primary IP address of the outbound interface.

Verifying the Configuration

  • Run the display current-configuration | include ntp command to view the configuration about the local source interface for sending and receiving NTP packets.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 42367

Downloads: 358

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next