Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deleting a Stack Member Port
Deleting a stack member port is to restore it as a service port.
Procedure (Versions Later Than V200R002)
- Run the system-view command to enter the system view.
- Run the interface stack-port member-id/port-id command to enter the logical stack port view.
- Run the shutdown interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> command to set the stack member ports to Down.
- Run the undo port interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> enable command to remove the stack member ports from the logical stack port and restore them as service ports.
Procedure (V200R002 and Earlier Versions)
- Run the system-view command to enter the system view.
- Run the interface stack-port member-id/port-id command to enter the logical stack port view.
- Run the undo port member-group interface interface-type interface-number command to remove stack member ports from the logical stack port.
- Run the quit command to return to the system view.
- Run the undo stack port interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> enable command to restore stack member ports as service ports.