No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Up an SVF System (AP Access)

Setting Up an SVF System (AP Access)

Context

In an SVF system shown in Figure 4-11, APs can be connected to the parent, level-1 ASs directly and indirectly, and level-2 ASs.

Figure 4-11  AP access

NOTE:
  • If APs need to be connected to the SVF system and managed by the parent, the parent must be the S12700/S9700/S7700/S6720HI/S5720HI/S5730HI and the S12700/S9700/S7700 must have X series cards installed.

  • When APs are connected to a non-X series card, you must add the non-X series card and X series card of the parent to the same WLAN work group. By default, all interface cards automatically join the default WLAN work group named default.

  • When an AS connects to APs, all member ports of the Eth-Trunk bound to the fabric port that connects the parent to the AS must be ports on X series cards or ports on non-X series cards. Otherwise, APs cannot go online.

Procedure

  • Connect an AP to the parent.

    When an AP is connected to the parent, the access configuration performed on the parent is the same as that on an AC. For details about connecting an AP to an AC, see the S5720 and S6720 V200R013C00 Configuration Guide - WLAN-AC.

  • Connect an AP to an AS.
    1. Run system-view

      The system view is displayed.

    2. Run uni-mng

      The uni-mng view is displayed.

    3. Run port-group connect-ap name group-name

      An AP port group is created and the AP port group view is displayed.

      You can create only one AP port group.

    4. Add the ports that connect ASs to APs to the AP port group.

      • Run as name as-name interface { { interface-type interface-number1 [ to interface-number2 ] } &<1-10> | all }

        Ports of the AS with a specified name are added to the AP port group.

      • Run as name-include string interface all

        Ports of ASs of which the name contains a specified string are added to the AP port group.

    5. Run quit

      Exit from the AP port group view.

    6. Run commit as { name as-name | all }

      The configuration is committed.

    7. Other AP connection configurations or service configurations, for example, the AP authentication mode and AP profiles, are the same as those performed when an AP is connected to an AC. For details, see S5720 and S6720 V200R013C00 Configuration Guide - WLAN-AC.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 42639

Downloads: 360

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next