No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using the Stack Assistant Tool to Quickly Obtain Information

Using the Stack Assistant Tool to Quickly Obtain Information

Figure 3-1 shows the stack assistant tool page.
Figure 3-1  Stack assistant tool page
Figure 3-2 describes how to use this tool:
  1. Starting from Stack & SVF type, select S Switches iStack > Switch series > Switch sub-series > Switch model > Software version > Connection mode > Stack cable > Switch stacked together in sequence.

    Click behind Stack cable to view the images of cables.

    NOTE:

    To check whether a switch supports service port stacking using dedicated stack cables, perform the following operations: Select Service port stacking, and then check whether you can select 0.5m and 1.5m SFP+ dedicated stack cable or 0.5m and 1.5m SFP+ dedicated stack cable (supported from V200R011C10) as stack cables. If so, switches of this model support service port stacking using dedicated stack cables.

  2. Click Query after finishing the selection. The stack precautions, connection rules, and software configuration are displayed. Set up a stack according to the information.

Figure 3-2  Tool page after Query is clicked
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 43810

Downloads: 372

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next