No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, monitoring interface, OPS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring 1588v2 on a TC

Configuring 1588v2 on a TC

TC Deployment

As shown in Figure 14-16, NodeBs synchronize with the external clock and support 1588v2. Core devices on the bearer network synchronize clocks with the grandmaster clock and send clock signals to downstream devices. Devices functioning as TCs transmit PTP messages between BCs or OCs. In this manner, BCs and OCs can synchronize their clocks. This deployment allows devices that do not have high clock requirements to only transmit 1588v2 messages, ensures synchronization precision, and improves synchronization efficiency.

Figure 14-16  Configuring 1588v2 on a TC

Pre-configuration Tasks

Before configuring 1588v2 on a TC, complete the following tasks:

  • Set link layer protocol parameters for interfaces to ensure that the link layer protocol status of the interfaces is Up.

  • Ensure that the Grandmaster clock correctly receives clock and time signals from the external clock source.

  • Configure synchronous Ethernet to synchronize the clock frequency on the network.

Configuration Procedure

The process of configuring 1588v2 on a TC is as follows.

Updated: 2019-04-20

Document ID: EDOC1100065674

Views: 76841

Downloads: 515

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next